Wismec WS-M DTL 0.27ohm coils 5 pack


2 in stock


**These replacement sub ohm coils are intended for use with the Wismec Sinuous V80 kit as well as the Amor NS Pro, Amor NS, ELABO SW, ELABO mini, ELABO, Reux mini and the Amor mini tanks.

Wismec although not the most well-known vape brand, have been around for a while now steadily pumping out one innovative vape after another. High quality devices designed in the US and then manufactured in China.

WS-M 0.27Ω – Kanthal + Mesh 30-60W (Best 35-45W)

These coils offer deep and rich flavour and excellent vapour production at a low wattage. Being a mesh coil, you can expect super-fast heating and optimal wicking.

To use: It is VERY important to prime any new coils as this starts the wicking process and helps to prevent dry hits (can damage the coil and will taste awful). To prime simply unscrew the drip tip, top cap and glass tube (all in one piece) off the base to expose the enclosed coil. Unscrew the used coil and set aside.

Time to prime. Screw in your new coil – make sure it is not too tight as you will need to remove it again. Drip a small amount of your e juice onto the exposed cotton all around the perimeter of the coil as well as the interior. Screw the reassembled tank back onto your mod (510 threaded) and time to fill. To fill the tank side-slide the top of the tank and you can now add your e liquid via a dropper into the slot (be careful to not drip any into the centre airflow tube). Slide back the top cap and allow the unit to sit for a few minutes (10-15). Now time for the primer puffs – without touching the firing button take a few sharp short pulls from the tank. You may see air bubbles rising to the top of the tank. You are now ready to vape!

Contains – 5 pack of WS-M 0.27Ω Coils


There are no reviews yet.

Be the first to review “Wismec WS-M DTL 0.27ohm coils 5 pack”

Your email address will not be published. Required fields are marked *

4 + 5 =

Ship in the harbour, as a air plane fly's over. Ship in the harbour, as a air plane fly's over.